Hello NI Community,
I'm facing a weird issue with our setup. The issue with our equipment when sending an analog signal into port AI3, the signal voltage drops when connected via a T-junction. The problem is not the T-junction itself, but there appears to be significant signal "leak" when both wires are connected to the T-junction which is connected to AI3 on our board. The voltage sent to AI3 could be 5V or it could be 10V, it doesn't matter, but the test panel voltage reads as 1.6V and dropping to 1.4V when both wires are connected.
I'm wondering if this could be an issue with the board itself, or the BNC cable connections? We also recently upgraded our equipment, and we are now using a Vidrio vDAQ board to generate the analog signal sent to the BNC-2110. Any help/suggestions are appreciated, I am new to this work and trying to learn. (Apologies for the messy setup, cable management hasn't been the priority of this team)
Thanks!