Dear all,
I used to do a lot of LabView long time ago, and I am a bit rusty...
I am trying to implement 'Buffered Edge Counting' as illustrated in the X-series manual, fig7.3 ( that I attached just in case).
I am a bit lost...
I know that I need to use the internal 100MHz clock base as 'source', and the signal that I want to know when arrives is named the 'sample clock'.
When I go to table 7.8 of the same manual is stated that for 'Buffered Edge Counting', the purpose of source terminal is 'input terminal'...
But none of the examples available on LabView (under "Hardware Input and Output" --> "DAQmx" --> "Counter Measurements") seems to correspond to a 'Buffered Edge Counting'.
I am using a bit old version, LabView 11.0.1, with DAQmx14.5. The hardware is a USB-6343 of the X-Series.
Anybody willing to share a very basic vi screen-shot to illustrate it, together with where the input needs to be connected (hardware I mean)???
Thanks in advance!!!
Confession: The worst of all is that I already did the same thing 15 years ago with a E series and I can not find the code...