I recently moved the PCI-6602 card from an old windows machine to a new one. With the 6602 card, I need to send 5 individual signals out to trigger lasers and cameras. Matlab is currently not recognizing the 6602 card, so relevant questions I'm attempting to debug:
1. Does 6602 work on Windows 10, or is this only for older systems?
2. Will I need a new download of Measurement & Automation Explorer on the new computer / where can I get this if this isn't a new order from NI?
Once that works, we also have a new PXIe-4492 card to synchronize pressure sensors with cameras. Basically, once the incoming pressure reading reaches a certain value, it will trigger the camera to start recording and the pressure data to be saved. I'd also like to send a signal to begin the laser system on the 6602 side. Both will be controlled by the same computer, ideally, but we are not sure how to interface them. We know it can't be impossible but are not sure to start, so any ideas would be hugely appreciated.
Thanks so much!!