Hi,
I am an undergraduate student and a beginner in Labview and learned the basics of labview. I want to measure temperature by K-type thermocouple with my NI 6001 DAQmx USB device. I am not an engeneer in electronics but learned a little on how SPI(serial peripherial interference) works. I found and downloaded from ni.com a vi code that is for temperature measurement. I don't use DAQ assistant instead I use DAQmx. My problem is when I connect the USB to computer the physical channels for DI and DO lines immediately appear, however, for Counter channel it does not appear therefore I cannot choose any channel. Where is the mistake I am doing? I tried many times and coud not solve the problem. I hope any of experts can find an answer to my problem.
this is the link for the vi code:
http://ftp.ni.com/pub/devzone/epd/serial_wfm_1_0_1_lv82.zip
Thanks in advance