I'm using LabVIEW 8.2. Calling the property node CI.CountEdges.DigFltr.Enable generates an error that my hardware does not support this property. The hardware documentation lists 4 debounce settings: 125 ns, 6.425 µs, 2.54 ms, and disable. Using the example vi "Meas Dig Frequency-Low Freq 1 Ctr.vi" to measure the pulse rate of a flow meter operating between 5 and 300 Hz, I'm getting results that occasionally match the rate displayed on the oscilloscope but more often range between 30 kHz and 5 MHz. The debounce filter seems like the perfect solution but I haven't been able to figure out how to enable or set it.
↧