Hello,
I am using LabVIEW 2025 with the cRIO-9042.
I am a beginner with LabVIEW.
I would be happy if you could teach me. I have two problems. The first is about AO output. I want to set it up so that it outputs at a specified time.
For example: 2 seconds → output 1.1.
I want it to work like that. The second is about AI display.
I want the loop to run in 0.1-second increments and save every 0.1 seconds for 10 seconds or 1 second, but it ends at 0.8 seconds. I can't figure out the cause even after researching, so I would like someone to help me. Since this text is created through translation, if anything is unclear, I can explain immediately.
Thank you very much.