Routing the PXI Controller 'SMB trigger port' to a PXIe-6674T timing and synchronization module for 'SMB to SMA' input / output.

I'm trying to get some verification from NI gurus (…or Emerson) regarding the capabilities of the PXIe-6674Ttiming and synchronization module while using the following LabView libraries:

* NI Sync Library API

* NI DAQmx Library API

For most of the NI-Sync vi's, the timing and synchronization functions work fine for routing and generating a signal or trigger event. However, I really need to verify/clarify the following specific issues:

1. How do you setup the PXIe-6674T to receive (or send) a trigger source using NI-Sync through the ‘PXIe-6674TSMA terminals’ TO the ‘SMB trigger port (on the Embedded Controller - ex: PXIe-8861/8881)’?

     2. My understanding is that DAQmx API and the NI-Syncedge detection VI's are not supported on the PXIe-6674T. Is this correct?

     3. How do you setup the PXIe-6674T to simply route the SMB trigger port to the SMA terminals?

Any help in verifying what function 'are' OR 'are not' supported by the PXIe-6674T module would be great!

Especially 'routing the SMB trigger port to the SMA terminals'  and  'receiving/detecting an external trigger using the PXIe-6674T'.

Note: My external trigger source is a function generator.